Press feeding lines deliver more potential through power.

Presses in use: Read the success stories of our national and international customers to find out why ARKU is the ideal partner for complex coil systems.

PERI GmbH, Germany: CompactFeed® coil line.

The PERI Group is the largest international manufacturer and provider of formwork and scaffolding systems. PERI continuously develops new systems and intelligent solutions, while also constantly investing in automated production processes.

Problem/challenge:

From 2011 on, PERI planned to begin manufacturing punched parts in-house, which it had previously obtained from a supplier. To this end, the company purchased a used press. Up until that point, PERI had no experience with coil processing. For this reason, the company required extensive advice before purchasing a feeding line. In addition, the location of the press only allowed a limited amount of space for a feeding line.

Solution from ARKU:

CompactFeed® compact feeding line - feeder leveler for sheet thicknesses from 1 to 10 mm.

"ARKU offers the right service and support. That is why ARKU also handled obtaining the CE certification for the entire system."

- Stefan Schraml, Project Manager

  • PERI GmbH: CompactFeed® - coil line.

    From 2011 on, PERI planned to begin manufacturing punched parts in-house, which it had previously obtained from a supplier. Therefore the company purchased a used press. Up until that point, PERI had no experience with coil processing. For this reason, the company required extensive advice before purchasing a feeding line.

Benefits for the customer:

  • Comprehensive advice from ARKU, enabling the company to begin its own punched part production
  • Space savings - no need for a loop pit with the compact design
  • Allows the processing of thick sheet metal up to 10 mm directly from the coil

What the customer says:

  • "The deciding factor in favor of ARKU was the good reference from a friendly neighboring company and ARKU's experience with thick sheet metal." - Martin Baur, Segment Manager Scaffolding
  • "ARKU offers the right service and support. That is why ARKU also handled obtaining the CE certification for the entire system." - Stefan Schraml, Project Manager

Trade article.

Large quantities of stamped parts are required for scaffolds and formwork systems. Peri GmbH has found its solution for manufacturing these stamped parts. More information in the trade article:
"Starting stamped part production"

Additional information

Contact details

PERI GmbH
Schalung Gerüst Engineering
Rudolf-Diesel-Straße 19
89264 Weißenhorn

www.peri.de

Did you know…

We also integrate levelers into turnkey press feeding lines, cut-to-length lines and coil preparation systems for roll forming lines.

To the feeding lines